Washington State University
SAFETY POLICIES AND PROCEDURES MANUAL

CHEMICAL / HAZARDOUS MATERIAL SAFETY
5.68
Revised 1-11
Environmental Health and Safety
335-3041

Storage of Dangerous Chemical Waste

PDF link

CONTROL

Storage of dangerous chemical waste is governed by local, state, and federal regulations.

Related Procedures and Guidelines

See 5.66 for procedures concerning reporting chemical waste for collection.

For chemical identification guidelines, refer to the Environmental Health nd Safety (EH&S) Hazardous Wastes Identification website at:

http://ehs.wsu.edu/es/WasteIdentification.html

Questions

Refer storage questions to Environmental Health and Safety (EH&S); telephone 335-3041.

Locations

University laboratories and departments may store chemicals in the following types of locations:

Satellite Accumulation Areas

A satellite accumulation area is a location at or near the point of generation where chemical wastes initially accumulate. (WAC 173-303-040) These chemicals are under the control of the individual who is responsible for their generation, e.g., maintenance worker, researcher, instructor, process operator, unit administrator, or their designee.

Any site of waste generation on the WSU campus which is not directly controlled by EH&S or is not identified as a 90-day accumulation area is considered a satellite accumulation area. Laboratories and shops are examples of satellite accumulation areas.

See "Requirements" below for regulatory requirements for satellite accumulation areas.

90-Day Accumulation Area

"90-day accumulation areas" are locations specifically identified by EH&S where wastes may be accumulated for not more than 90 days. After 90 days wastes must be transported to a permitted treatment, storage or disposal facility. (WAC 173-303-200)

Contact EH&S for regulatory requirements for 90-day accumulation areas; telephone 335-3041.

REQUIREMENTS

Satellite Accumulation

Each laboratory, shop, or departmental building waste accumulation area at WSU is considered by regulatory agencies to be a satellite accumulation area. (WAC 173-303-040)

Personnel storing chemical wastes at satellite accumulation areas must follow these requirements:

Container Management

Keep the container under control of the operator or in a secured (locked) area.

Close the container during storage, except when adding or removing waste.

Allow waste from only one process per container.

Place wastes in compatible containers.

Container Labeling

Mark each container with a label that clearly identifies the chemicals. See 5.66 for labeling requirements.

Volume of Waste

The maximum volume of any waste that may be stored in a satellite accumulation area is 55 gallons, unless the waste is acutely hazardous.

The maximum volume of acutely hazardous waste that may be stored in a satellite accumulation area is one quart.

See the EH&S website to view the Acutely Hazardous Waste List. Go to:

http://ehs.wsu.edu/es/AcutelyHazardousWaste.html

Time Limits

When 55 gallons of dangerous waste or one quart of acutely hazardous waste are generated, mark the date on the container label. See the EH&S Hazardous Wastes Identification website for definitions of chemical waste types. Go to:

http://ehs.wsu.edu/es/WasteIdentification.html

Move the container to a 90-day accumulation area within three days.

If these waste volumes remain in a satellite accumulation area for more than three days, the area must meet the more stringent 90-day accumulation area requirements.

90-Day Accumulation (Pullman Campus)

EH&S operates the Chemical Storage Building on the Pullman campus as the central 90-day accumulation area. EH&S transports wastes from all Pullman campus accumulation areas to Chemical Stores to be processed and shipped to approved recycling and disposal facilities.

90-Day Accumulation (Branch Campuses and Research Facilities)

Each branch campus and research facility is to maintain a 90-day accumulation area. Contact EH&S branch campus/research station support personnel for information and assistance; telephone 335-3041.